HKVS # help cmd 'help' is not supported. HKVS #  cmd '' is not supported. HKVS # help The following commands are supported: trspt boot erase help reset saveenv printenv setenv upbs format update upfusb upf updatebusb updateb gos go mii gpio ping Use 'help' to get help on a specific command HKVS # printenv ipaddr=192.168.1.70 serverip=192.168.1.128 gatewayip=0.0.0.0 netmask=255.255.255.0 ethaddr= loadaddr=0x00208000 bootfile=hImage bootcmd=null bootargs=console=ttyS0 bootdelay=2 chip_id=0 HKVS # HKVS # help The following commands are supported: trspt boot erase help reset saveenv printenv setenv upbs format update upfusb upf updatebusb updateb gos go mii gpio ping Use 'help' to get help on a specific command HKVS # ? cmd '?' is not supported. HKVS # printenv ipaddr=192.168.1.70 serverip=192.168.1.128 gatewayip=0.0.0.0 netmask=255.255.255.0 ethaddr= loadaddr=0x00208000 bootfile=hImage bootcmd=null bootargs=console=ttyS0 bootdelay=2 chip_id=0 HKVS # help trspt Help for 'trspt': Usage:trspt set|get disable|enable get - get transparent mode set - set transparent mode disable - disable transparent mode enable - enable transparent mode HKVS # help go Help for 'go': HKVS # help gos Help for 'gos': HKVS # help boot Help for 'boot': boot Load images from flash to memory and boot HKVS # help reset Help for 'reset': reset Reboot the system by reseting hardware HKVS # help mii Help for 'mii': MII utility commands mii info -display MII PHY info, --> start[-end] mii read -read MII PHY register mii write -write MII PHY register mii dump -pretty-print (0-5 noly) Addr and/or reg may be ranges, e.g. 2-7. HKVS # help gpio Help for 'gpio': gpio [set|clr|get|pup|pdown|poff] id - Basic GPIO function gpio [hw] id func - Set HW mode Test GPIO. HKVS # help upbs Help for 'upbs': load binary file(u-boot_g1.bin) over serial line (xmodem mode) and update HKVS # help upf Help for 'upf': update firmware, format and update (factory use) HKVS #