resetting ...

IPL g40bd5ed
D-0a
HW Reset
SPI 54M
128MB
BIST0_0001-OK
MXP found at 0x0000f000
offset:00010000
Checksum OK

IPL_CUST g40bd5ed
MXP found at 0x0000f000
offset:00020000
XZ decomp_size=0x00045e44


U-Boot 2015.01 (Mar 22 2023 - 07:52:09)

Version: I6g#######
I2C:   ready
DRAM:  
WARNING: Caches not enabled
MMC:   MStar SD/MMC: 0
nor_flash_mxp allocated success!!
Flash is detected (0x0B05, 0xC8, 0x40, 0x18)
SF: Detected nor0 with total size 16 MiB
MXP found at mxp_offset[2]=0x0000F000, size=0x1000
can not found mxp record: UBOOT_ENV
Flash is detected (0x0B05, 0xC8, 0x40, 0x18)
SF: Detected nor0 with total size 16 MiB
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Net:   MAC Address <mac:2f1814cacc230fcd>
Auto-Negotiation...
AN failLink Status Speed:10 Full-duplex:0
Status Error!
sstar_emac
Warning: sstar_emac using MAC address from net device

gpio debug MHal_GPIO_Pad_Set:603
gpio[78] is 1
gpio debug MHal_GPIO_Pad_Set:603
gpio[79] is 1
gpio debug MHal_GPIO_Pad_Set:603
gpio[14] is 1
gpio debug MHal_GPIO_Pad_Set:603
gpio[15] is 0
gpio debug MHal_GPIO_Pad_Set:603
gpio[52] is 0
gpio debug MHal_GPIO_Pad_Set:603
gpio[47] is 0
gpio debug MHal_GPIO_Pad_Set:603
gpio[46] is 0
gpio debug MHal_GPIO_Pad_Set:603
gpio[47] is 1
SigmaStar # help
?       - alias for 'help'
aes     - Control Mstar AES engine
base    - print or set address offset
bootm   - boot application image from memory
bootp   - boot image via network using BOOTP/TFTP protocol
btime   - Show booting time
cmp     - memory compare
cp      - memory copy
crc32   - checksum calculation
dbg     - set debug message level. Default level is INFO
dcache  - enable or disable data cache
debug   - Disable uart rx via PAD_DDCA to use debug tool
dhcp    - boot image via network using DHCP/TFTP protocol
dstar   - script via SD/MMC
eeprom  - EEPROM sub-system
env     - environment handling commands
estar   - script via network
estart  - EMAC start
fatinfo - print information about filesystem
fatload - load binary file from a dos filesystem
fatls   - list files in a directory (default /)
fatsize - determine a file's size
fwupdate- fwupdate command allows to flash vc camera firmware from file on mmc or from memory.
go      - start application at address 'addr'
gpio    - Config gpio port
help    - print command description/usage
i2c     - I2C sub-system
icache  - enable or disable instruction cache
initDbgLevel- Initial varaible 'dbgLevel' 
loop    - infinite loop on address range
macaddr - setup EMAC MAC addr
md      - memory display
mm      - memory modify (auto-incrementing address)
mmc     - MMC sub system
mmcinfo - display MMC info
mssdmmc - Mstar SD/MMC IP Verification System
mstar   - script via TFTP
mw      - memory write (fill)
mxp     - MXP function for Mstar MXP partition
nm      - memory modify (constant address)
ping    - send ICMP ECHO_REQUEST to network host
printenv- print environment variables
reset   - Perform RESET of the CPU
riu     - riu  - riu command

run     - run commands in an environment variable
saveenv - save environment variables to persistent storage
sdstar  - script via sd package
secauth - Control Sstar security authenticate sequence
setenv  - set environment variables
sf      - SPI flash sub-system
sfbin   - for uploading sf image to a server(via network using TFTP protocol)
sigauth - Only verify digital signature and aes
srcfg   - sensor pin and mclk configuration.
test_sig- Test runAuthenticate2

tftpboot- boot image via network using TFTP protocol
uart    - UART sub-system
version - print monitor, compiler and linker version
SigmaStar # printenv
baudrate=115200
bootargs=mem=130840K console=ttyS0,115200  LX_MEM=0x7fe0000 mma_heap=mma_heap_name0,miu=0,sz=0x4000000 rootfs1
bootcmd=sf probe 0; sf read 0x22000000 0x60000 0x500000; bootm 0x22000000; setenv bootargs $(bootargs) bkp=1;0
bootdelay=0
ethact=sstar_emac
ethaddr=<mac:2f1814cacc230fcd>
preboot=gpio output 78 1;gpio output 79 1;gpio output 14 0;gpio output 15 0;gpio output 52 0;gpio output 47 0;
stderr=serial
stdin=serial
stdout=serial

Environment size: 652/4092 bytes
SigmaStar # version

U-Boot 2015.01 (Mar 22 2023 - 07:52:09)
arm-buildroot-linux-uclibcgnueabihf-gcc.br_real (Buildroot 2017.08-gc7bbae9) 4.9.4
GNU ld (GNU Binutils) 2.28.1
SigmaStar #