NbAak_fixed_clk_probe: parameters ok, nf=100 nr=1 nb=16 freq=400000000 pll2 frequency out: 400MHz gclk frequency out: 200MHz U-Boot 2019.10.0-V4.0.21 (Apr 08 2024 - 14:15:57 +0800) CPU: 860MHz Boot mode: secure Model: EVB_CBD_AK3918AV100N_V1.0.0 board DRAM: 64 MiB ak_fixed_clk_probe: parameters ok, nf=100 nr=1 nb=16 freq=400000000 ak_fixed_clk_probe pll2 has inited! pll2 frequency out: 400MHz gclk frequency out: 200MHz Flash: SF: Detected XM25QH64C with page size 256 Bytes, erase size 4 KiB, total 8 MiB 8 MiB MMC: ak3918av100_gpio_probe @get_card_status, card PLUGED mmc1@20108000: 0 Loading Environment from SPI Flash... OK In: uart0@20130000 Out: uart0@20130000 Err: uart0@20130000 Net: No ethernet found. Autoboot in 3 seconds mmc power off ... SF: Detected XM25QH64C with page size 256 Bytes, erase size 4 KiB, total 8 MiB device 0 offset 0x4c000, size 0x2f5000 SF: 3100672 bytes @ 0x4c000 Read: OK SF: Detected XM25QH64C with page size 256 Bytes, erase size 4 KiB, total 8 MiB device 0 offset 0x3e000, size 0xce1c SF: 52764 bytes @ 0x3e000 Read: OK --->sb spend 0 ms ## Booting kernel from Legacy Image at 80008000 ... Image Name: Linux-4.4.282 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2943880 Bytes = 2.8 MiB Load Address: 80008000 Entry Point: 80008040 Verifying Checksum ... OK ## Flattened Device Tree blob at 81300000 Booting using the fdt blob at 0x81300000 Loading Kernel Image Using Device Tree in place at 81300000, end 8130fe1b Starting kernel ... Uncompressing Linux... done, booting the kernel.