root@xm530-sc3335:~# dmesg devpts: called with bogus options Module dwc_common_port init dwc_otg: version 3.30a 13-OCT-2015 Core Release: 3.30a Setting default values for core params INFO:: Host Mode. Using Descriptor DMA mode Periodic Transfer Interrupt Enhancement - disabled Multiprocessor Interrupt Enhancement - disabled OTG VER PARAM: 0, OTG VER FLAG: 0 Dedicated Tx FIFOs mode dwc_otg dwc_otg.0: DWC OTG Controller dwc_otg dwc_otg.0: new USB bus registered, assigned bus number 1 dwc_otg dwc_otg.0: irq 76, io mem 0x00000000 Init: Power Port (0) usb usb1: New USB device found, idVendor=1d6b, idProduct=0002 usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1 usb usb1: Product: DWC OTG Controller usb usb1: Manufacturer: Linux 3.10.103+ dwc_otg_hcd usb usb1: SerialNumber: dwc_otg.0 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected usbwifi_init. 0x82 PDN pin is low, ouput high and delay 2 sec. gpio:96 : 0x82 ouput high and delay 2000ms Indeed it is in host mode hprt0 = 00021501 usb 1-1: new high-speed USB device number 2 using dwc_otg Indeed it is in host mode hprt0 = 00001101 usb 1-1: New USB device found, idVendor=007a, idProduct=8888 usb 1-1: New USB device strings: Mfr=16, Product=32, SerialNumber=0 usb 1-1: Product: AltoBeam_WIFI usb 1-1: Manufacturer: AltoBeam inc. cfg80211: Calling CRDA to update world regulatory domain xm_i2c init is ok! mmz: init ok start=0x82300000, size=0x1d00000 VI: init ok! IspKo: ispDev_init start! IspKo: ispDev_init OK! hx280enc: module init - base_port=0x20070000 irq=77 hx280enc: HW at base <0x20070000> with ID <0x82900760> hx280enc: module inserted. Major <0> xm_rtc init is ok! xm_wdt init is ok! acodec init is ok! MVE: Failed to create 'mve' dir. MVE: Failed to create 'dmesg' dir. MVE: Failed to create 'ram0' dir. MVE: Failed to create 'ram0/msg. MVE: Failed to create 'generic' dir. MVE: Failed to create 'scheduler' dir. MVE: Failed to create 'firmware_interface' dir. MVE: Failed to create 'session' dir. MVE resource driver loaded successfully (nlsid=4, cores=1, version=0x56550002) MVE base driver loaded successfully cfg80211: Calling CRDA to update world regulatory domain [atbm_log]:atbm_usb_module_init 0 [atbm_log]:SVN_VER=20811,DPLL_CLOCK=2,BUILD_TIME=[===USB-ARES_B== [atbm_log]:Probe called -1 v1 [atbm_log]:not CONFIG_USE_DMA_ADDR_BUFFER [atbm_log]:CONFIG_TX_NO_CONFIRM [atbm_log]:Allocated hw_priv @ c168cec0 [atbm_log]:atbmwifi USB_USE_TASTLET_TXRX enable (c168cec0) [atbm_log]:atbmwifi USB_USE_TASTLET_TXRX enable (c168cec0) [atbm_log]:atbm_before_load_firmware++ [atbm_log]:atbm_HwGetChipType, chipver=0x49, g_wifi_chip_type[10] [atbm_log]:+++++++++++++++++1.1v++++++++++++++++++ [atbm_log]:===================~_~==================== [atbm_log]:atbm_start_load_firmware++ [atbm_log]:used firmware.h= [atbm_log]:START DOWNLOAD ICCM========= [atbm_log]:atbm_load_firmware_generic: addr 10000: len 22000 [atbm_log]:START DOWNLOAD DCCM========= [atbm_log]:atbm_load_firmware_generic: addr 800000: len 8000 [atbm_log]:atbm_after_load_firmware++ [atbm_log]:0x1610102c=0x40a0e [atbm_log]:0x1610102c=0x10a0f [atbm_log]:0x16101000=0x8000e08 [atbm_log]:set_block_size=256 [atbm_log]:mdelay wait wsm_startup_done !! [atbm_log]:firmwareCap f58f [atbm_log]:firmwareCap2 51ae [atbm_log]:wsm_caps.firmwareCap 51aef58f [atbm_log]:apollo wifi WSM init done. Input buffers: 32 x 2048 bytes Hardware: 7.1280 WSM firmware [=MODEM=RF=Ares_AX 2GHZ Apr 19 2022 18:53:51NOTXConfrim], ver: 14195, build: 2807, api: 1060, cap: 0x51AEF58F Config[30008] expection 900a5c0, ep0 cmd addr 901be2c NumOfStations[8] NumOfInterfaces[3] [atbm_log]:EFUSE(8) [0] [atbm_log]:EFUSE(I) [1] [atbm_log]:EFUSE(B) [0] [atbm_log]:CAPABILITIES_ATBM_PRIVATE_IE [1] [atbm_log]:CAPABILITIES_NVR_IPC [1] [atbm_log]:CAPABILITIES_NO_CONFIRM [1] [atbm_log]:CAPABILITIES_SDIO_PATCH [0] [atbm_log]:CAPABILITIES_NO_BACKOFF [0] [atbm_log]:CAPABILITIES_CFO [0] [atbm_log]:CAPABILITIES_AGC [1] [atbm_log]:CAPABILITIES_TXCAL [1] [atbm_log]:CAPABILITIES_MONITOR [0] [atbm_log]:CAPABILITIES_CUSTOM [1] [atbm_log]:CAPABILITIES_SMARTCONFIG [0] [atbm_log]:CAPABILITIES_ETF [1] [atbm_log]:CAPABILITIES_LMAC_RATECTL [1] [atbm_log]:CAPABILITIES_LMAC_TPC [1] [atbm_log]:CAPABILITIES_LMAC_TEMPC [1] [atbm_log]:CAPABILITIES_CTS_BUG [0] [atbm_log]:CAPABILITIES_USB_RECOVERY_BUG [1] [atbm_log]:CAPABILITIES_USE_IPC [1] [atbm_log]:CAPABILITIES_OUTER_PA [0] [atbm_log]:CAPABILITIES_POWER_CONSUMPTION [1] [atbm_log]:CAPABILITIES_RSSI_DECIDE_TXPOWER [0] [atbm_log]:CAPABILITIES_RTS_LONG_DURATION [1] [atbm_log]:CAPABILITIES_TX_CFO_PPM_CORRECTION[1] [atbm_log]:CAPABILITIES_SHARE_CRYSTAL [0] [atbm_log]:CAPABILITIES_HW_CHECKSUM [0] [atbm_log]:CAPABILITIES_SINGLE_CHANNEL_MULRX [0] [atbm_log]:CAPABILITIES_CFO_DCXO_CORRECTION [1] [atbm_log]:EX_CAPABILITIES_TWO_CHIP_ONE_SOC [0] [atbm_log]:EX_CAPABILITIES_MANUAL_SET_AC [0][atbm_log]:EX_CAPABILITIES_LMAC_BW_CONTROL [1] [atbm_log]:EX_CAPABILITIES_SUPPORT_TWO_ANTENNA [0][atbm_log]:EX_CAPABILITIES_ENABLE_STA_REMAIN_ON_CHANNEL [1] [atbm_log]:EX_CAPABILITIES_ENABLE_PS [0][atbm_log]:EX_CAPABILITIES_TX_REQUEST_FIFO_LINK [0] [atbm_log]:EX_CAPABILITIES_CHIP_TYPE 6032IS [atbm_log]:CONFIG_PRODUCT_TEST_USE_FEATURE_ID [1] [atbm_log]:CONFIG_PRODUCT_TEST_USE_GOLDEN_LED [1] i2c_write timeout 0x2 [atbm_log]:wsm_generic_confirm:status(2) [atbm_log]: wsm_write_mib fail !!! mibId=4132 [atbm_log]:apollo wifi : can't open /data/.mac.info [atbm_log]:efuse data is [0x1,0x28,0x1b,0x1a,0x1c,0xf,0x0,0x0,0xf4:0xb1:0x9c:0xa8:0xca:0x1f] [atbm_log]:apollo wifi : can't open /tmp/atbm_txpwer_dcxo_cfg.txt [atbm_log]:apollo wifi : can't open /tmp/set_rate_power.txt [atbm_log]:get chip id [94][1][1] [atbm_log]:current chiptype 6032is [atbm_log]:enable sg i2c_write timeout 0x2 [atbm_log]:is registered as 'ALTOBEAM' [atbm_log]:[atbm_wtd]:set wtd_probe = 1 usbcore: registered new interface driver atbm_wlan i2c_write timeout 0x2 i2c_write timeout 0x2 i2c_write timeout 0x2 i2c_write timeout 0x2 [atbm_log]:br0_netdev_open()-1197: dev_get_by_name(br0) [atbm_log]:atbm_hw_scan:if_id(0) [atbm_log]:atbm_hw_scan:scan, delay suspend [atbm_log]:scan start band(0),(14) i2c_write timeout 0x2 i2c_write timeout 0x2 IspKo: [IspDrv]: Memery Init Buffer!Num[2] [atbm_log]:hw_priv->scan.status 0 [atbm_log]:atbm_scan_work:end(0) [atbm_log]:wlan0:free authen bss ++ [atbm_log]:authen:(),ssid(Frodo) [atbm_log]:[TX]:authen, delay suspend [atbm_log]:wlan0: authenticated [atbm_log]:wlan0:free authen bss ++ [atbm_log]:wlan0:free authen bss -- [atbm_log]:wlan0: associated [atbm_log]:[]:40M channel [atbm_log]:ieee80211_recalc_ps:work busy [atbm_log]:ieee80211_recalc_ps:work busy [atbm_log]:ieee80211_process_addba_request:mac[],tid[0] [atbm_log]:ieee80211_recalc_ps:work busy [atbm_log]:ieee80211_process_addba_request:mac[],tid[6] [atbm_log]:atbm_bss_info_changed 749 ,pmMode = 0 [atbm_log]:atbm_bss_info_changed 760 : pmMode(0) rx ampdu ++ [atbm_log]:atbm_bss_info_changed 1284:pmMode = 0 [atbm_log]:wsm_set_pm:pmMode:0,fastPsmIdlePeriod:255,apPsmChangePeriod:0,minAutoPsPollPeriod:0 [atbm_log]:[PM]:rev ind [atbm_log]:[PM]:up pm lock i2c_write timeout 0x2 i2c_write timeout 0x2