Skip to content
← All news

· by OpenIPC team

A new silicon vendor, and a camera you can bring up from your phone

OpenIPC now builds firmware for two Axera chips, a tunnel built into three of our apps reaches a camera with no address of its own, the Live page gained a full set of steering controls, and a HiSilicon recorder chip came up with SATA so ordinary hard drives work.

A new silicon vendor: Axera

OpenIPC now builds firmware for two Axera chips — the AX620E and the four-core AX620U. Both start on our own bootloader, built from source: all that is left of the vendor's is the small piece the boot ROM needs to bring up the RAM. The kernels are the vendor's, with Axera's drivers ported into them, and the whole vendor media stack comes up on top. If the firmware will not boot, a camera on either chip can be recovered over the network or from an SD card.

What there is not yet: a working camera. All of this was checked in the emulator, we have not run it on a live board, and majestic does not stream on Axera — it has no backend for these chips. Only the stock application sends video, which is how we know the hardware itself is fine.

You can bring a camera up, and watch it, from your phone

We have camex: a tunnel that reaches a camera even when it has no address of its own on the internet. It used to be a program you ran separately. It can now be built straight into an app, and three of ours did exactly that.

vectis is a small adapter board — it powers the camera and brings out its console. It now has an Android app that runs even on a TV box without root, and the console opens as an ordinary web page, behind a password if you want one.

microsnander reads and writes flash chips. Its app learnt to work through the tunnel: pull a dump, look through it byte by byte, and flip a bit in the chip's register with one tap.

The decoder plays camera video on Android and on televisions. It gained a Network window, which connects to the camera through the same tunnel.

None of them needs port forwarding or a public address.

Steering a camera got comfortable, and autofocus stopped clicking

The Live page in the web interface gained a whole set of controls: draw a box on the picture and the camera turns to it; save a position, or a whole scene, and come back to it with one tap; there is iris control, a gallery of the frames where autofocus found its sharpness, and triggers that refocus the camera on an event.

While you are steering, settings are no longer written to flash on every nudge: the write happens once, when you let go. On a chip whose settings live in NOR, that noticeably extends the memory's life.

Autofocus itself got quieter: it no longer clicks, no longer stalls, picks the right point of sharpness, and refocuses after the camera switches between day and night. If there is nothing in the frame to focus on, it now says honestly that it could not — it used to report success. On Anyka chips a pan/tilt head can be driven from plain processor pins, with no separate controller.

A recorder with real disks

The Hi3520D V100 is a chip for a video recorder rather than a camera, and this week it came up far enough to work as one: clocks and reset, USB, a real-time clock and the crypto engine all run, and — the part that matters — so does SATA, which means ordinary hard drives can be plugged into it. The first board this was checked on is a Juan NVR0408, for four cameras.

The camera stops guessing what its own filesystem is

To mount the root partition, the kernel used to try every filesystem it knows, one after another, until one of them took. Now it mounts the one the partition actually holds, and if the partition cannot be read it tries only the two types it could possibly be. The fix was written once and ported to seventeen platforms, from the Goke GK710x to the Hi3519DV500, both SigmaStar families among them.

Split NOR is the standard now, not the exception

The firmware wizard on the site says so plainly: on every processor we publish such images for, the split layout is the standard, and Lite on an 8 MB camera is the split image, because that is the one that fits. This week the layout reached every Ingenic board, SigmaStar's infinity6c, every neo build, and the mainline Linux 7.0 kernel.

Goke's GK7206 and Anyka's chips became cameras

majestic now runs on the Goke GK7206V1 family, and with it these cameras got everything you expect from a camera: neural-network noise reduction, audio, text on the picture, motion detection, night mode and slow shutter in auto-exposure. Image tuning can be written as text now, instead of feeding the camera a binary file from the vendor.

Anyka's EV200, EV300 and the AV100 family came up as well — the camera captures and encodes through the kernel's own drivers, on the EV300 in H.265 too. And a PE3020-W looks at its own light sensor and decides for itself that night has fallen.

Also

Thirty repositories saw work this week, and 411 pull requests were merged.

  • qemu-bench built a complete digital twin of the Fullhan FH8626V100 — from boot to login, with its coprocessor, its frame path and its H.264 and JPEG encoders — and added twins for the Hi3518EV200, the Anyka AV130 and AV100, the Goke GK7206V11A running Xiongmai's stock firmware, and both Axera chips.
  • the wiki wrote down that the AltoBeam ATBM6032 Wi-Fi chip works on the XM530 and what the XM711 image actually ships, that Novatek's IMX415 is supported but has to be set by hand and that Ctrl-C stops the vendor's bootloader, and which chip sockets are worth buying for a programmer.
  • firmware brought up that ATBM6032, added Ingenic T41 boards, released the image for the GK7206 family, and tuned a long list of sensors.
  • u-boot built Axera's bootloader from source with the stock one as a fallback, added the Anyka AV100 family, and stops the watchdog at boot on every processor.
  • builder added the Misecu XM-63-AI-50W, HeimVision HM202 and VStarcam C23S cameras, an anbiux XM530 board and an Imou whose card slot now works; coupler added a GK7205V300 20x zoom block and a Rostelecom camera.
  • ipctool learnt to recognise the Axera chips, tell a T41ZX from a T41A, and name the GK7206 family; defib read a GK7206's whole 16 MB through its boot ROM.
  • nvr now reports memory sensibly on cameras with under a gigabyte, and its dark theme and page layout were put in order.
  • openhisilicon replaced two vendor blobs with builds from source; openingenic built the T41 modules; waybeam cut memory use on the CV610 from 37 to 21 MiB at 1080p30.
  • divinus, onvif-tt, aviateur and motors carried protocol, test and Windows fixes; sensors drove SigmaStar's imx335 and sc850sl; smolrtsp, smolrtsp-libevent and mavfwd took maintenance work; website re-staged the whole catalogue, put the board and report pages in order, and accepted build reports from two more vendors.